Varnish protects the surface from scratches and impact cleaning chemicals. Thorough pre-paint the door surface preparation helps to ensure a quality end result. The old surface was washed and flaking paint is removed. Irregularities shpatlyuyut, for example, alkyd putty Spakkeli, after which the surface is sanded until smooth. Ground surface napimer, Exy primer or swelling.
After priming produces a light sanding. Color produce, for example, paint empiricism. Stained conventional solid doors do not cause problems, but the paneled door is much harder to paint. Larger areas can be divided into several sections, if not the entire surface have time to paint until the paint has dried. On solid doors is recommended to apply the paint roller mohair, then straighten the surface yet with a wide brush.
When painting panel doors, first recommended to paint solid surface of the door. Excess paint spilled across the panels, remove the wet cloth. The output of the line tape makes it easy. Stained windows by changing the load of construction equipment and domestic water, and on the exterior window frames increases. Building denser than before, and, consequently, the moisture content in the air inside the building went up. Wooden box wood, used for window frames, not always from core, and the type of wood varies. In Finland, the industrial manufacturing, windows make up to full readiness, including the color at the factory. Unpainted windows deliver little. Most ready-stained windows, but only a small portion is treated with glaze. As a primer for factory use polyurethane primer and paint for a finishing – alkyd, or polyurethane paint katalitnye. Before entering to the color of windows should be check that the window frame was quite dry. At the same wood moisture should be less than 20% when measured at a depth of 5 mm. Before staining, sharp edges ukruglyayut polishing, then brush the surface clean from dust and dirt.